Description

特点：

1. Ø10mm 的直柄可安装于切削夹头或钻夹头上(参考图1)。

2. 请以手指轻压测定子的侧边， 使其偏心0.5mm(参考图2)。

3.  使其以400-600 rpm的速度转动。

4. 如(图2)所示使测定子与加工物的端面相接触， 一点一点地碰触移动，就会变成如(图3)所示， 测定子不再振动，宛如静止的状态接着，以更细微的 进给来碰触移动的话，测定子就会如(图4)所示，开始朝一定的方向滑动。这个滑动起点就是所要寻求的基准位置。

5. 加工物本身的端面位置，就是加上测定子半径5mm的坐标位置。

Features :

1. Ø10mm straight shank can be installed directly on milling chuck or drilling chuck.(refer to Fig. 1)

2. Press slightly on edge of sensor unit with hands to keep eccentricity at 0.5mm .

3. Rotate with speed of 400-600 rpm.

4. Make sensor unit contact to the end face of workpiece shown as Fig. 2.Then, contact and move gradually, it is going to turn into Fig. 3 and sensor unit keeps still. Furthermore, if fine feed is started, then sensor unit will move according to a specific direction. The start point of this movement is the basis position to look for.

5. The position of end face of the workpiece is the coordinate position of sensor unit plus radius 5mm.